Hi,
This is Apoorv from SRM University, India. We are currently in the fabrication phase of our vehicle. For our chassis main hoop we used 25.4mmX2.5mm round tubes and got them bended. After bending the outer diameter reduced upto 24.5mm. We could not check the thickness of our tube.
Is this dimension of tube acceptable in competition as the outer OD is now 24.5. Do need to check the thickness as well and keep it at least 2.4mm. As the bend is very smooth and fine we are assuming that thickness must not have decreased much. Also rule book doesnt say anything about this.
 |
|
|
Reply With Quote
