threepoints
07-09-2012, 05:46 PM
Dear all:
I try this case and can't find out solution, if anybody know, please give me a answer
1. I create a line(L1) and 2 points(P1,P2,P3)
2. line mesh for L1
3. virtual rigid part L1>>P1, and also L1>>P2
4. Fix P3
5. Create a virtual spring part L1>>P3
6. Apply a force to P1
My question is L1=100mm originally, but after calculation, L1 is 100.02mm
Could I create a connection and keep bar length?
If fact, I am doing some mechanism analysis, however, some mechanism needs bush then works, therefore I want to use CATIA FAE module to do this.
Thank you for your response...
3PTs
I try this case and can't find out solution, if anybody know, please give me a answer
1. I create a line(L1) and 2 points(P1,P2,P3)
2. line mesh for L1
3. virtual rigid part L1>>P1, and also L1>>P2
4. Fix P3
5. Create a virtual spring part L1>>P3
6. Apply a force to P1
My question is L1=100mm originally, but after calculation, L1 is 100.02mm
Could I create a connection and keep bar length?
If fact, I am doing some mechanism analysis, however, some mechanism needs bush then works, therefore I want to use CATIA FAE module to do this.
Thank you for your response...
3PTs