Stock GXSR Header Dimensions

[nathan s]

Anyone know what they are? (ie, inner dia and length)

Thanks,

[nathan s]

Anyone know what they are? (ie, inner dia and length)

Thanks,

[Blake_DFSAE]

we just got an IGES model for it, although it may be an old version...not sure yet, still converting piece by piece

if it turns out that it's the newest model i can help you

[Blake_DFSAE]

Oh and this would be a 96-00 model if it's the one we want

[nathan s]

That is cool. I am actually working on an 01 and 05, but I don't think the header dimensions would change that much. Mostly, I am just looking for a starting place to put into Ricardo.

If you come up with anything, any info would be great.

Thanks,

[Blake_DFSAE]

I can measure ID actually, we have the pipe sitting in the shop. Length might be a bit more difficult to get accurate.

[Mark TMV]

Well, there is a 'low-tech' solution - take a piece of wire, pick 2 reference points for start and end, and follow the length of the pipe and then measure the length of the wire.

[Blake_DFSAE]

argh...it's an older air-cooled model from the generation before

it was actually something done by a solid modelling class back in the mid 90s as a project...too good to be true

[Blake_DFSAE]

And I haven;t had access to the IC engines lab so I haven't been able to take measurements...plus I saw that the pipe is on the engine at the moment.

I can get you the OD and assume a small thickness (it ain't much). However, either way it'll have to wait - SPRING BREAK 06 TREMBLANT!

BTW, I think the old solid model still uses the same mounting pts too so I may be able to find those realy accurately.

[nathan s]

OD is fine, anything helps. I can measure the thickness of our header tubes that we have. I imagine they are all about the same thickness.

Thanks,

Nathan