mxt
04-21-2005, 10:00 AM
Hey Everyone,
Just a quick question. I had a question about the requirements for the roll bar padding. It states that the foam must be non-resilient, however, it does not say if it has to be SFI approved or not. Would the padding in the below link be ok? Or would we need an SFI approved foam?
Thanks
http://www.jegs.com/cgi-bin/ncommerce3/ProductDisplay?prrfnbr=4734&prmenbr=361
Just a quick question. I had a question about the requirements for the roll bar padding. It states that the foam must be non-resilient, however, it does not say if it has to be SFI approved or not. Would the padding in the below link be ok? Or would we need an SFI approved foam?
Thanks
http://www.jegs.com/cgi-bin/ncommerce3/ProductDisplay?prrfnbr=4734&prmenbr=361