28 spline shaft

[jane17]

hey guys, i cant get a 28 teeth spline shaft. so plz tell how to get it or is there any alternate to it.....this is our first year car....so plz help us out....v r vry sry for cribbig u guys...

[jane17]

hey guys, i cant get a 28 teeth spline shaft. so plz tell how to get it or is there any alternate to it.....this is our first year car....so plz help us out....v r vry sry for cribbig u guys...

[Charlie]

What in the world are you trying to say?

If you are going to ask for help you should attempt to write decent sentences, or at least make clear what the heck you are asking.

[Pete M]

I second what charlie said...

I did get "28 teeth" and "spline" out of that though. Can't you find someone who cuts splines and get them to do whatever you need?

[Composites Guy]

y u b axing our un-standin uh da "28 spline"? better splain urself fast!

[Scotty]

Jane17

Are you trying to say you are looking for 28 splined axles ?
If so....I have them in 5 differant sizes.
11 5/8 min to 23 max.
You can see them on the web site.

http://www.taylor-race.com/subcat1.cfm?category=Drive%20Axle%20Components

Hope this this helps ya

[Composites Guy]

I think that Moser (http://www.moserengineering.com/) can do the spline machining for you also. For other teams that have spline machining and broaching done (as opposed to buying finished axles or doing the work in-house)... who does your machining?

[TG]

I'm not sure if Moser can do 28 spline... I think they just go down to 30. I just ordered a 31 spline short axle for winters quick-change rear end at my job and it was heavy as all hell (over 12 lb for a 17" long axle)... they couldn't gun drill it for some reason. So unless you plan on spending >$300 to get the axle and then have it gun drilled separately, I'd not go that path.

[Composites Guy]

I meant lathe the axle yourself, heat-treat it and send it to Moser to be splined. Look on their website under "shop services". I wasn't aware of a 30 spline minimum limit to their capabilities.