Chittad
12-07-2007, 11:46 AM
Hello everybody,
I was going through RCVD and in the chapter on Suspension Geometry, the author uses 'Descriptive Geometry' to find out the inner pivot axis.
I fairly understood what was written. But I was still unsure of how should one go about it when caster is included in the side view.
Should one project all the points from the front view onto the line joining the upper and the lower ball joints (which results from the inclusion of caster) instead of projecting them on the center line?
I was going through RCVD and in the chapter on Suspension Geometry, the author uses 'Descriptive Geometry' to find out the inner pivot axis.
I fairly understood what was written. But I was still unsure of how should one go about it when caster is included in the side view.
Should one project all the points from the front view onto the line joining the upper and the lower ball joints (which results from the inclusion of caster) instead of projecting them on the center line?