Scott M.
09-13-2002, 11:10 AM
Superior Engine Technology (SET) is searching for schools to participate in an ECU application development program for Formula SAE. SET is offering exclusive support for FSAE and the F4i combination.
Key features of this engine control system:
-Base calibration included
-NO MACHINING REQUIRED
-Uses FACTORY sensors/injectors/coils
-Dedicated FSAE support
-Free strategy updates
-On board data logging to 250Hz
Contact SuperiorEngineTechnology@yahoo.com for a list of all the features as they apply to FSAE.
The latest software and strategy are always available on the Advanced Engine Management (AEM) forum at AEMPower.com (http://AEMPower.com)
This is a Wire & Play system. ALL the factory sensors/pickups/coils/injectors can be used. NO machining is required to operate with this system. A factory F4I wiring harness can be used once re-terminated. Each team will receive a custom hardware package to meet your specific needs. Support includes an online FSAE forum and a competition support program for the 2003 Detroit event.
The applying school must meet the following minimum requirements:
-Have previous stand-alone fuel injection experience (Motec, Electromotive, Haltech, etc.)
-Use a Honda CBR 600 F4i engine
-Use a dynamometer for tuning
-Use a UEGO sensor full time (NTK, DIY WB, etc.)
-Have at least one key member committed to the engine program
-Can offer suggestions for new hardware and software features
-Submit calibrations upon completion
-Searching for a cost-effective highly advanced system with exclusive support.
Note: Forced induction is desirable but is not required.
If you are tired of not having "total control" contact SuperiorEngineTechnology@yahoo.com for more information.
Scott Matas
Penn State
1994-1996
[This message was edited by Scott M. on September 13, 2002 at 04:14 PM.]
Key features of this engine control system:
-Base calibration included
-NO MACHINING REQUIRED
-Uses FACTORY sensors/injectors/coils
-Dedicated FSAE support
-Free strategy updates
-On board data logging to 250Hz
Contact SuperiorEngineTechnology@yahoo.com for a list of all the features as they apply to FSAE.
The latest software and strategy are always available on the Advanced Engine Management (AEM) forum at AEMPower.com (http://AEMPower.com)
This is a Wire & Play system. ALL the factory sensors/pickups/coils/injectors can be used. NO machining is required to operate with this system. A factory F4I wiring harness can be used once re-terminated. Each team will receive a custom hardware package to meet your specific needs. Support includes an online FSAE forum and a competition support program for the 2003 Detroit event.
The applying school must meet the following minimum requirements:
-Have previous stand-alone fuel injection experience (Motec, Electromotive, Haltech, etc.)
-Use a Honda CBR 600 F4i engine
-Use a dynamometer for tuning
-Use a UEGO sensor full time (NTK, DIY WB, etc.)
-Have at least one key member committed to the engine program
-Can offer suggestions for new hardware and software features
-Submit calibrations upon completion
-Searching for a cost-effective highly advanced system with exclusive support.
Note: Forced induction is desirable but is not required.
If you are tired of not having "total control" contact SuperiorEngineTechnology@yahoo.com for more information.
Scott Matas
Penn State
1994-1996
[This message was edited by Scott M. on September 13, 2002 at 04:14 PM.]