UBRacing Launch!!

[ben]

We finished the bloody thing didn't we!!

Pictures to follow, I'm here at 6:45 in the morning and #17 has just been born.

Ben

www.ubracing.co.uk (http://www.ubracing.co.uk)

[ben]

We finished the bloody thing didn't we!!

Pictures to follow, I'm here at 6:45 in the morning and #17 has just been born.

Ben

www.ubracing.co.uk (http://www.ubracing.co.uk)

[ben]

Ok - based on that post I was a little bit giddy with lack of sleep. Anyhow - here she is;

Front 3/4 View (http://members.aol.com/benmichell/front_3_4.jpeg)

Rear End (http://members.aol.com/benmichell/rear_1.jpeg)

Rear Corner - check out the driveshaft! (http://members.aol.com/benmichell/rear_corner.jpeg)

Side Pod (http://members.aol.com/benmichell/side_pod.jpeg)

Ben

[James Waltman]

Those driveshafts are pretty sweet. They look filament wound, is that the case? Did you make them, have them made, or modify them from something else?

James Waltman
waltmaj@cc.wwu.edu
http://dot.etec.wwu.edu/fsae/
Formula SAE
Vehicle Research Institute at
Western Washington University

[ben]

Yes they are filament wound. We have two alumni at CTG who suppply carbon propshafts and ARBs to a lot of WRC and FIA GT teams, and they were produced there.

I believe they are also making a CFRP driveshaft kit but you'd have to contact them direct.

www.ctgltd.co.uk (http://www.ctgltd.co.uk)

Ben