F4i Specs for modeling

[Chris Hand]

Hi, I am going to be trying to model our F4i engine in GT-Power, and before I tear it apart to measure everything, I am wondering if someone would be willing to share some of the harder to find dimensions, stuff you need to take the engine apart for. Such as the cam profile, piston pin offset, rod length etc.

Thanks,
Chris

[Chris Hand]

Hi, I am going to be trying to model our F4i engine in GT-Power, and before I tear it apart to measure everything, I am wondering if someone would be willing to share some of the harder to find dimensions, stuff you need to take the engine apart for. Such as the cam profile, piston pin offset, rod length etc.

Thanks,
Chris

[Charlie]

The piston pin offset is pretty tough to measure. I'd say it's around .1 or .2 mm. I've posted the rod length I measured on the listserv and I believe here as well.

Cam profiles are too much of a PITA to give away! http://fsae.com/groupee_common/emoticons/icon_wink.gif

-Charlie Ping
Auburn University FSAE 1999-present
http://eng.auburn.edu/organizations/SAE/AUFSAE/sig.jpg