Karam El Hady
03-10-2017, 07:14 AM
hello
i'd like to ask if using square tube like pic is permissible
1131
i have 3 Frame Members on each side of the vehicle; an upper member; lower member and diagonal brace and in our chassis upper member is two tube one square and the other is round
is that permissible?
in SES report when i input data about bulk head support structure i have 3 Frame Members on each side of the vehicle; an upper member; lower member and diagonal brace and in our chassis upper member is two tube one square and the other is round when i input data i have two opinions round and square but i use both
in the cell i have to square or round tube but i used both 1133
i'd like to ask if using square tube like pic is permissible
1131
i have 3 Frame Members on each side of the vehicle; an upper member; lower member and diagonal brace and in our chassis upper member is two tube one square and the other is round
is that permissible?
in SES report when i input data about bulk head support structure i have 3 Frame Members on each side of the vehicle; an upper member; lower member and diagonal brace and in our chassis upper member is two tube one square and the other is round when i input data i have two opinions round and square but i use both
in the cell i have to square or round tube but i used both 1133