Mohamed Aziz
12-02-2016, 05:42 PM
Hello,
I want to make sure that my dimensions are compatible with rules.
According to the two rules T3.19.2 & T3.14.4 ,The Front Hoop braces must be attached as near as possible to the top of the Front Hoop but not more than 50.8 mm (2 in) below the top-most surface of the Front Hoop. The upper support member must be attached within 50mm (2”) of the top surface of the Front Bulkhead, and attach to the Front Roll Hoop within a zone extending 100mm (4”) above and 50mm (2”) below the Upper Side Impact member.
So, is these dimensions in the picture correct (within rules)?
1063
I want to make sure that my dimensions are compatible with rules.
According to the two rules T3.19.2 & T3.14.4 ,The Front Hoop braces must be attached as near as possible to the top of the Front Hoop but not more than 50.8 mm (2 in) below the top-most surface of the Front Hoop. The upper support member must be attached within 50mm (2”) of the top surface of the Front Bulkhead, and attach to the Front Roll Hoop within a zone extending 100mm (4”) above and 50mm (2”) below the Upper Side Impact member.
So, is these dimensions in the picture correct (within rules)?
1063