ECU detecction

[broomstickpyjamas]

hi!ive done the wiring completely.but the ecu is not getting detected by the computer.what cud b the problem.the latches r in place.help?neone?

[Tim.Wright]

Well, if the latches are already in place I don't think there is anything else which CAN be done.

Tim

[Jon @ Electromotive, Inc.]

You haven't given us much to go on. What is the ECU? Is it getting power? Are there trouble shooting tips in the manual.

Lack of communication is most likely due to no power to the ECU. After that, communcations setup (port number, drivers, etc) than possibly a bad communications cable.

If the ECU you are using is unusual to FSAE, your best bet for help will probably be the manufacturer.