New Full 3D Kinematic Suspension Design Tool

[dynatune]

Hi Guys, I have been busy lately and I am proud to present to you all the NEW DYNATUNE SUSPENSION DESIGN MODULE. The kinematics tool you have always wanted. You can read all about it on http://www.dynatune-xl.com/new-dsdm-70.html. Feedback is appreciated.

Cheers,
dynatune, www.dynatune-xl.com

[Silente]

didn´t have time to look at it properly yet.

Just one question anyway: does it allow to model Push/Pull Rod geometries by default, or they should be defined somehow by the user?

[dynatune]

This version does not allow push/pull rod suspension since it is focused on the suspension kinematics but it will give you the motion ratio of the spring/damper unit and if mounted in the suspension as if it was a pushrod/pull rod it will give you a base ratio. The rest is very basic geometry. Multiplying that base motion ratio with the motion ratio of the rocker (leverarm of spring/damper attachment to rocker axis devided by leverarm of push/pull rod attachment to rocker axis) will give you the "real spring" motion ratio.

Cheers,
dynatune, www.dynatune-xl.com