Torsen Output Splines

[Dave Cook]

I have two new splined bars for use with the FSAE torsen special, I've ordered a custom hob to make the goofy 68 degree teeth that audi uses in their tranny. You can see them at www.paradigmmotorsports.com (http://www.paradigmmotorsports.com). One is a 1 3/4" dia bar of 4130 for welding to your own flanges. The second bar is 3 3/4" dia 4340 and good for making output flanges or even output tripod housings for Taylors small tripods.

I will have bars completed on Feb 1st. I'm making 10 small bars and only 4 to 6 of the bigger bars, I'll make more if I recieve enough interest.

Dave

[Dave Cook]

I have two new splined bars for use with the FSAE torsen special, I've ordered a custom hob to make the goofy 68 degree teeth that audi uses in their tranny. You can see them at www.paradigmmotorsports.com (http://www.paradigmmotorsports.com). One is a 1 3/4" dia bar of 4130 for welding to your own flanges. The second bar is 3 3/4" dia 4340 and good for making output flanges or even output tripod housings for Taylors small tripods.

I will have bars completed on Feb 1st. I'm making 10 small bars and only 4 to 6 of the bigger bars, I'll make more if I recieve enough interest.

Dave