Member |
All you veterans.... I need to get two axles out to a team in need... Is there a local machine shop that can machine the circlip grooves for them,,Or can the mobile GM machine shop do it... need some help here.... scotty Taylor Race scotty@taylor-race.com taylor-race.com | ||
|
| Member |
Not sure if the GM rig can cut them, but we have fixed a dremel tool to a lathe at really low RPM and ground the grooves in an emergency situation. Not very elegant, but it got the job done. Any old lathe that spins true can do the job. Ryan | |||
|
| Member |
Right on Ryan.... A flat table .grinder and some dude rolling tbe axle will even work.Just tryin to save these guys a couple bucks and make sure they get what tbey need..... but i never heard back from them... scotty Taylor Race scotty@taylor-race.com taylor-race.com | |||
|
Member |
Emergency? This is standard procedure bump for a good cause | |||
|
| Member |
Thanks Sormaz.. scotty Taylor Race scotty@taylor-race.com taylor-race.com | |||
|
| Member |
Scotty, If they're still in need and can come up to Brighton, I can get it done for them. If so, PM. | |||
|
| Member |
I'd ask the Michigan team. PM me if you need a contact. "Gute Fahrer haben die Fliegenreste auf den Seitenscheiben." --Walter Röhrl | |||
|
| Member |
kracer...... Are you getting any of this bud. The forum is coming through for ya dude.....where are ya. scotty Taylor Race scotty@taylor-race.com taylor-race.com | |||
|
© FSAE.com 2001-2011